This is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing
connector -to- the T.I. Amplifier Harness's molded rubber connector. Basically, it is the wiringfrom the amplifier box.
This part is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose theirgrip on the male terminals they connect to, causing your engine to quit!
Electrical components are non-returnable parts.
Always refer to a factory service manual when diagnosing engine service problems.You can damage electrical components if the proper procedures are not followed. Be sure you are replacing the correct part.